| 1. | Research on lpg free spray at low injection pressure
燃料喷雾过程的研究 |
| 2. | Adjust injection pressure and injection time
调整注塑压力和注塑时间 |
| 3. | Influence of the injection pressure to plastic mould core offset
注射压力对塑料模具型芯偏移量的影响 |
| 4. | Bottom - hole injection pressure
井底注水压力 |
| 5. | Laborotary experiment of water injection pressure decreasing by surfactant
表面活性剂降低注水井注入压力室内实验研究 |
| 6. | Raise injection pressure
增加注塑压力 |
| 7. | Peak injection pressure
峰值喷油压力 |
| 8. | Air injection pressure
空气喷射压力 |
| 9. | 1 . bouble cylinders balanced injection system 2 . multi - steps injection pressure and speed system
二多级压力，多级速度射胶系统 |
| 10. | The injection pressure of e30 engine corresponding to the lowest fuel consumption is higher than that of diesel engine
E30的最低燃料消耗率对应的喷嘴启喷压力略高于柴油。 |
